Filter
Top Products
MOBILE HOME INSTALLATION
When installed in a mobile home, the installation must conform to the Manufactured Home Construction and Safely
Standards, Title 24 CFR, Part 3280 (formerly Ihe Federal Standard for Mobile Home Construction and Safety, Title
24, HUD, Part 280).
Four-wire power supply must be used and the appliance wiring must be revised. See Electrical Requirements.
Copies of the standards listed may be obtained from:
‘Natlonal Fire Protect!on Assoclatlon
Batterymarch Park
Quincy, Massachusetts 02269
UNPACKING THE UNIT
Personal Injury Hazard
More than one person is required to lift or move
the oven because of Its welght and size.
Failure to follow these Instructions may result In
personal Injury.
The oven should ~YZ left on the carton base until it is ready to put into the
cabinet. It is also recommended that the pads over the door(s) be left in
place. These precautions will reduce the possibility of damage lo the front
of the unit and the bottom of the front frame.
Prlsr to installation, check the electrical service to assure that
it
agrees
with the specifications on the oven serial plate
To Remove Oven Rackr
Remove all cords, tape, and wire used to hold various parts In position dur-
Slide rack forward until bar on back of rack
ing shipment. Study all labels and tags and remove those on an exposed
touches
first
stop
surface after installation, unless instructed to leave them for the owner.
Clft front of rack until rear portIon of rack
Remove oven racks from the Inside of the oven and unwrap. Put
slides out between front two stops
to one side while the oven
IS
being installed in cabinet. Take broiler pan, grid, and any other accessories from the pack-
ing on top of the oven and keep them with literature packet In a locatlon where they will
be retained
for use by the owner.
ELECTRICAL CONNEflION
Electrical Shock Hazard
Disconnect power supply before making any electrical connections.
Failure to do so may result in electrical shock.
Connect the conduit
from the oven to the junction box and properly connect to the power supply leads The unit
IS
now
ready to install In cabinet
GROUNDING
- THE OVEN MUST BE GROUNDED
Do not work on the oven wiring until the oven has been positively grounded
The oven frame IS grounded through the bare grounding wire Connect the white neutral to the service neutral wire
at the junction box.