Filter
Top Products
REINSTALL DOOR (See Fig. 2)
1. Slide door on hinge arms until firmly seated.
2. Lower door to full open position.
3. Push finger tabs back. Depress the tabs and slide forward.
4. Close and reopen door slowly to make sure it has been replaced properly.
MICROWAVE OVEN OPERATIONAL CHECK
CHECK MICROWAVE OVEN AFTER INSTALLATION, FOLLOWING SEQUENCE BELOW.
1. Install glass tray or turntable tray supplied with the microwave unit.
2. Put suitable container filled with approximately
1
quart or liter of water into microwave.
3. Refer to the microwave and the thermal oven use and care guides to set the electronic clocks.
4. Touch number pads for cooking time. Set 10 minutes by touching “l”, the “0” three times. “IO 00” should
appear in Display Window.
5. Touch “START” pad. Make sure that cavity light comes on. The oven WIII start cooktng and the Display Win-
dow will show time remaining, counting down in seconds.
6. After about 5 minutes, check door switches by opening and closing the door several times. Unit should stop
when door is opened, light goes out only when door is reclosed. Unit should start again when door is closed
and “START” is touched and the light comes on again.
7. Continue to operate unit. A tone sounds for 2 seconds when the time IS up and the unit will automatically shut off.
8. Check to see that water is hot.
NOTE: Maintain at least one half quart or one half liter of water in container during test.
Specifications subject to change without notice.
Part No. 3177139 Rev B
@989 KitchenAid, Inc
Prepared by KitchenAid. St. Joseph, Michigan 49085
Printed in U.S.A