Filter
Top Products
18
Section 7: Troubleshooting
PR1560 & PR1572 Powered Rakes 314-164M
Land Pride
7/14/08
Table of Contents
Section 7: Troubleshooting
Problem Solution
Machine makes intermittent clicking
noise
Check for damaged gear and replace if necessary
Check for worn drive chain and replace if necessary
Roller will not turn
Obstruction between roller and material control deflector
Chain off
Burnt or mis-adjusted slip-clutch on driveline shaft
Broken drive spindle
Operating depth insufficient
Raise gauge wheels
Increase tractor RPM
Clean roller
Roller gouging on the end
The gauge wheel on chain case side should be approximately 1” lower than the
non-drive side gauge wheel for consistent leveling
Set gauge wheel depth
Correct air pressure in gauge wheels
Level 3-point arms on tractor
Too much dirt going into the windrow or
dirt going over the top of the material
control deflector
Reduce ground speed
Raise material control deflector
Lower gauge wheels
Too many rocks passing between
material control deflector and the roller
Lower material control deflector
Roller balling up with soil
Wait until soil dries
Powered Rake bumping on ground
Clean roller