Filter
Top Products
C-1
ACCESSORIES
C-1
OPTIONS/ACCESSORIES AND COM-
PATIBLE LINCOLN EQUIPMENT
K957-1 HEAVY DUTY, TWO WHEEL TRAILER FOR
SMALL WELDERS
For road, off-road and in-plant and yard towing.
(For highway use, consult applicable federal, state and
local laws regarding requirements for brakes, lights,
fenders, etc.).
K1737-1 FOUR WHEEL ALL-TERRAIN UNDERCAR-
RIAGE For moving by hand.
K1770-1 UNDERCARRIAGE (FACTORY)
For moving by hand on a smooth surface. One or two
gas cylinders can be mounted on the rear of the
undercarriage with the installation of K1745-1 Cylinder
Holder(s).
K1739-1 CABLE CARRIER KIT
For use on K1737-1 and K1770-1 Undercarriages.
K1745-1 SINGLE GAS CYLINDER HOLDER
For use on K1770-1 Undercarriage. One or two may be
installed on an undercarriage.
K1788-1 ROLL CAGE - Gives added damage protection.
K886-2 CANVAS COVER - Protects machine when not in use.
S24647 SPARK ARRESTOR
Mounts inside exhaust pipe.
K702 ACCESSORY KIT
Accessory set includes 35 ft. (10.7 meters) 2 AWG
electrode cable, 30 ft. (9.1 meters) 2 AWG work cable,
headshield with No. 12 filter, GC300 work clamp and
Cooltong 300 electrode holder. Cables are rated at 250
amps, 40% duty cycle.
K857 28 ft (8.5m) or K857-1 100 ft. (30.4m) REMOTE
CONTROL
Portable control provides same dial range as the output
control on the welder. Has a convenient 6 pin plug for
easy connection to the welder.
K1690-1 GFCI RECEPTACLE KIT
Includes one UL approved 120V ground fault circuit
interrupter duplex type receptacle with cover and
installation instructions. Replaces the factory installed
120V duplex receptacle. Each receptacle of the GFCI
Duplex is rated at 20 Amps, the maximum total current
from the GFCI Duplex is limited to the 20 Amps.
Two kits are required.
K802-N POWER PLUG KIT
Provides four 120 volt plugs rated at 20 amps each
and one dual voltage, full KVA plug rated at 120/240
volts, 50 amps.
K802-R POWER PLUG KIT
Provides four 120 volt plugs rated at 15 amps each
and one dual voltage, full KVA plug rated at 120/240
volts, 50 amps.
T12153-9 50 AMP, 120/240 V POWER PLUG
K1816-1 FULL KVA ADAPTER KIT
Plugs into the 120/240V NEMA 14-50R receptacle on
the casefront (which accepts 4-prong plugs) and
converts it to a NEMA 6-50R receptacle, (which
accepts 3-prong plugs.)
RANGER 305G