Filter
Top Products
C-1
ACCESSORIES
C-1
CLASSIC 300G
OPTIONAL EQUIPMENT (Field Installed)
Accessory Set (K704) - Includes 35 ft. (10.7m) elec-
trode and 30 ft. (9.1m) work cables, headshield, work
clamp and electrode holder.
Pipe Thawing with an arc welder can cause fire,
explosion, damage to electric wiring or to the arc
welder if done improperly. The use of an arc
welder for pipe thawing is not approved by the
CSA, nor is it recommended or supported by
Lincoln Electric.
------------------------------------------------------------------------
Power Plug Kit (K802D) - A 20 amp power plug kit
for the auxiliary power receptacles is available.
(Provides a plug for each receptacle.)
Remote Control Kit (K924-4) - Contains switch,
receptacle, remote control rheostat, and 100 ft
(30.5m) cable for adjusting the OCV at the welding
site.
Trailer (K953-1) - Two-wheeled trailer with optional
fender and light package. For highway use, consult
applicable federal, state, and local laws regarding
possible additional requirements. Their is a choice of
2 hitches, a fender & a light package. Order:
K953-1 Trailer
K958-1 Ball Hitch
K958-2 Lunette Eye Hitch
K959-1 Fender & Light Kit.
K965-1 Cable Storage Rack
Remote Control Kit (K924-5) - Contains a remote
control rheostat, and 100 ft. (30.5m) cable for adjust-
ing the OCV at the welding site.
Remote Control Kit (K2464-1) - Contains a remote
control rheostat (for adjusting the CC “STICK” OCV),
remote control potentiometer (for adjusting the CV
“WIRE” OCV), and 100ft.(30.5m) cable.
Wire Feed Module (K623-1) - Provides constant
voltage (CV) output with improved arc stability for
Innershield welding. Excellent for MIG welding.
Recommended wire feeders are the LN-7, LN-23P
and LN-25.
GFCI Receptacle Kit (K1690-1) - Includes one UL
approved 115V ground fault circuit interrupter duplex
type receptacle and installation instructions. Replaces
the factory installed 115V duplex receptacle. Each
receptacle of the GFCI duplex is rated at 20 amps.
Maximum total current from the GFCI duplex is limited
to 20 amps.
TIG Module - Portable, high frequency unit with gas
valve for TIG welding. Rated at 300 amps / 60% duty
cycle. (Request Publication E3.205).
Order K930-2
Control Cable - Connects TIG Module to the Classic
300G.
Order K936-4
Arc Start Switch - Provides on/off control at the TIG
Module.
Order K814
Contactor Kit - For use with TIG Module.
Order K938-1
Control Cable Extension - Allows the TIG Module to
be operated at distances up to 200 ft. from the power
source. Availiable length: 45 ft. (13.7m).
Order K937-45
Water Valve Kit - For use with a water-cooled TIG
Torch. Installs inside of TIG Module.
Order K844-1
K2261-1 OIL DRAIN KIT - Includes ball valve, hose
and clamp.
WARNING