Filter
Top Products
#$*$$
+""*()
When working on the fuel system:
• Keep naked lights away, do not smoke !
• Do not spill fuel !
-------------------------------------------------------------------------
The AIR VANTAGE® 500 (AU) is equipped with a F6=
:=E6C located after the lift pump and before fuel injec-
tors.The procedure for changing the filter is as follows.
1. Close the fuel shutoff valve.
2. Clean the area around the fuel filter head. Remove
the filter. Clean the gasket surface of the filter head
and replace the o-ring.
3. Fill the clean filter with clean fuel, and lubricate the
o-ring seal with clean lubricating oil.
4. Install the filter as specified by the filter manufactur-
er.
#6492?:42=@G6CE:89E6?:?8H:==5:DE@CEE96E9C625D
7:=E6C6=6>6?ED62=@C7:=E6C42?
-------------------------------------------------------------------------
%%"$)/)*#
The AIR VANTAGE® 500 (AU) is equipped with a
pressure radiator. Keep the radiator cap tight to pre-
vent loss of coolant. Clean and flush the coolant sys-
tem periodically to prevent clogging the passage and
over-heating the engine. When antifreeze is needed,
always use the permanent type.
**(/$"$
))(%#**(/42?6IA=@56
P!66ADA2C<D7=2>62?54:82C6EE6D
2H2J7C@>32EE6CJ
*@AC6G6?E.&"%)%$H96?
P$)*""$$-**(/5:D
4@??64E?682E:G6423=67C@>@=532E
E6CJ7:CDE2?54@??64EE@?6H32EE6CJ
=2DE
P%$$*$**(/((
(6>@G632EE6CJ7C@>H6=56C3J5:D
4@??64E:?8?682E:G6423=67:CDEE96?
A@D:E:G6423=62?532EE6CJ4=2>A
-96?C6:?DE2==:?84@??64E?682E:G6
423=6=2DE!66AH6==G6?E:=2E65
P+)$%%)*(4@??64EA@D:E:G6
=625E@32EE6CJ7:CDEE96?4@??64E?682
E:G6=625E@6?8:?67@@E
**(/$+($/)$
)!$
P-62C8=@G6D2?56J6AC@E64E:@?2?5
3642C67F=H96?H@C<:?8?62C32EE6CJ
@==@H:?DECF4E:@?DAC:?E65@?32EE6CJ
------------------------------------------------------------------------
-
&(,$*$"*("#
1. When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper polarity
must be observed. Failure to observe the proper
polarity could result in damage to the charging cir-
cuit. The positive (+) battery cable has a red termi-
nal cover.
2. If the battery requires charging from an external
charger, disconnect the negative battery cable first
and then the positive battery cable before attaching
the charger leads. Failure to do so can result in
damage to the internal charger components. When
reconnecting the cables, connect the positive cable
first and the negative cable last.
&(,$*$**(/)(
Turn the RUN/STOP switch to stop when engine is
not running.
&(,$*$**(/+!"$
Tighten nuts on battery clamp until snug.
(,$*Q+
-($$
-($$