Filter
Top Products
A-1
INSTALLATION
SAE400 WELD’N AIR
A-1
TECHNICAL SPECIFICATIONS - SAE400 WELD’N AIR
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
Perkins 4 cylinder High Idle 1800 236 cu. in
12VDC batteries
Fuel: 22.5 gal.
4.236 Diesel 63 HP @ Low Idle 1100 (3.87 L)
(2
) & Starter 85.1 L
Engine 1725 RPM Full Load 1725
Bore x Stroke Oil: 8.5 Qts.
8.04 L
3.875” x 5.00”
(98.4 mm x 127.0mm) Coolant: 3.6 gal.
13.63 L
INPUT - DIESEL ENGINE
RATED OUTPUT - WELDER
HEIGHT WIDTH DEPTH WEIGHT
50.13 in. 28.00 in. 83.00 in. 2294 lbs.
1273.3 mm 711.2 mm 2108.2 mm 1040.6 kg
OUTPUT - WELDER AND GENERATOR
OUTPUT - AIR COMPRESSOR
Duty Cycle
(1)
Welding Output Volts at Rated Amps
60% (NEMA) 400 amps 36 volts
60% (Lincoln Plus) 400 amps 40 volts
Welding Range Open Circuit Voltage Auxiliary Power
80 - 575 Amps 97 Max. OCV 115/230 VAC
@ 1800 RPM 3000 Watts, 60 Hz.
100% Duty Cycle
Make/Model Description Delivery Tank Capacity & Rating Operating Pressure Oil Capacity
IMT 4-cylinder 35 CFM 11 Gallons Loads at 95 P.S.I. 1.33 Quarts
(Iowa Mold Reciprocating, at 100 P.S.I. (41.6 Liters) (6.7 kg/cm
2
) (1.26 Liters)
Tooling/ Diamond Water Cooled, at 60% Maximum Allowable Unloads at 125 P.S.I. IMT’s
Air) Pressure Lubricated Duty Cycle
(1)
Working Pressure (8.8 kg/cm
2
) Synthetic
Aluminum Alloy 991 Liters/min. 150 PSI Compressor
Model Block with Cast- at 7.0 kg/cm
2
(10.5 kg/cm
2
) Oil
DA435ELW Iron sleeves
PHYSICAL DIMENSIONS
(1)
Based on a 10 minute period.