Filter
Top Products
23
Chart Scroll
In normal operation, the sonar chart will scroll from right to left across
the screen. You can stop the chart from scrolling across the screen. This
is useful when you want to "freeze" the picture to study it more closely.
To stop the chart, press
MENU until the SCROLL SPEED menu appears. Use
the
DOWN ARROW to select MIN. The menu remains visible and a
stationary "Stop" message appears in the screen's top right corner.
To resume scrolling, use the
UP ARROW to select MAX (or any speed
other than minimum), then press
PWR to clear the menu. For most
fishing conditions you should return the chart to maximum speed.
(Read more about this in the later entry on Chart Scroll Speed.)
NOTE:
You cannot clear the menu until you raise the chart speed again. If
you accidentally press
PWR to clear the menu while the chart is
stopped, you must press
MENU until the SCROLL SPEED menu
reappears, then follow the instructions from the preceding
paragraph.
Full Chart
This shows all echoes scrolling across the full screen. This is the default
page. The bottom signal scrolls across the screen from right to left. The
line at the top of the screen represents the surface. The bottom depth
(as determined by the digital sonar) shows in the upper left corner.
Opening screen, Full Chart page, or mode.
The Fish I.D. feature is turned on.
If the transducer with a built-in temperature sensor is connected, a
digital display for water temperature will also be shown. This
temperature display can be turned on and off. See the later entry on
Temperature Size for off and on instructions.
Fish symbols
Grayline
®
Bottom signal
Digital depth
Depth range
at bottom of
depth scale
Surface signal
Water Temp
Structure
or cover