Filter
Top Products
NOTE
:
I
*When beginning the planing of
a
flat
shape, first take down the middle
of
the
workpiece, gradually planing until the
ultimate concave shape
is
achieved.
workpiece to obtain eventually
a
concave
First take down both
ends
of
the
workpiece
*When beginning the planing of
a
flat
workpiece to obtain eventually
a
convex
shape, first take down both ends of the
workpiece, gradually planing until the
ultimate convex shape
is
achieved.
First
take
down
the
middle
of
the
workpiece
Shiplapping or corner cuts (flush cuts)
When performing the shiplapping or corner
cuts (flush cuts up against
a
wall), remove
the wing bolt to take off the drum cover,
allowing flush-side work.
NOTE
:
Corner cuts (flush cuts up against
a
wall)
are impossible, of course,
if
the tool cannot
be moved forward or backward because of
a
wall
or
something blocking the tool path.
WARNING
:
With the drum cover removed for corner cuts (flush cuts) or shiplapping, be very careful
not to touch the drum/blades or allow your clothing to
be
caught during operation.
After performing the shiplapping or corner cuts (flush cuts), ALWAYS RE-INSTALL
THE
DRUM
COVER AND TIGHTEN THE WING BOLT SECURELY. Never forget to
switch off and unplug the tool, and wait for the blades to come to
a
complete stop
before re-installing the drum cover.
8