Filter
Top Products
Adjusting depth
of
cut
Depth of cut may be adjusted by simply
turning the knob on the front of the tool.
Switch action
To start the tool, simply pull the trigger.
Release
the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release
it.
Lock button
Trigger switch
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
Planing operation
First, rest the tool front base flat upon the
workpiece surface without the blades mak-
ing any contact. Switch on and wait until
the blades attain full speed. Then move the
tool gently forward. Apply pressure on the
front of tool
at
the start of planing, and
at
the back
at
the end of planing. Planing will
be easier
if
you incline the workpiece in
stationary fashion,
so
that you can plane
somewhat downhill. The speed and depth
of cut determine the kind of finish. The
power planer keeps cutting
at
a
speed that
will not result in jamming by chips. For rough cutting, the depth of cut can be increased,
while for
a
good
finish
you
should reduce the depth of cut and advance the tool more
slowly.
8