Filter
Top Products
7
• When using the bit with 6.35 mm (1/4”) shank diameter,
first remove the adapter from the collet cone, then install
the bit.
To install the bit, insert the bit all the way into the collet cone.
Press the shaft lock to keep the shaft stationary and use the
wrench to tighten the collet nut securely.
To remove the bit, follow the installation procedure in reverse.
OPERATION
CAUTION:
• Avoid forcing the bit to bend or twist. It may snap.
• Before turning the tool on, make sure the bit and collet
nut are securely tightened.
Hold the tool secure with the bit pointing in a safe direction
not contacting any surface and slide the switch to the ''ON''
position. Wait until the tool attains full speed.
When starting the multipurpose bit into the material, hold the
tool at approximately a 45 degree angle with the edge of the
shoe base contacting the material.
Carefully bring the tool to a straight position so the shoe
base is in full contact with the material.
1. Bit
2. Collet nut
3. Shaft lock
4. Adapter
5. Wrench
6. Loosen
7. Tighten
001626
1
2
3
4
5
7
6
001627
001628