Filter
Top Products
CAUTION
:
Always hold the tool with the base flush with the workpiece. Failure to do
so
may cause
*Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may
a
slanted cutting surface and blade breakage.
cause
a
slanted cutting surface and blade breakage.
Bevel
cutting
CAUTION
:
Always unplug the tool before making any adjustments.
With the base tilted,
you
can make bevel
cuts
at
any angle between
0"
and
45'
(left
or right). Loosen the bolt on the bottom of
the tool. Move the base
so
that the bolt
is
positioned in the center of the cross-shaped
slot in the base.
Tilt the base until the desired bevel angle
is
obtained. The edge of the motor housing
indicates the bevel angle by graduations.
Then tighten the bolt to secure the base.
Crossshaped
slot
Edge
of
motor
housing
/
/
Base
Graduations
Flush cutting
Loosen the bolt on the bottom of the tool and slide the base
all
the way back. Then
tighten the bolt to secure the base.
For
4304
10