Filter
Top Products
Finishing edges
To trim edges or make slight dimensional adjustments, run the blade lightly along the cut
edges.
'Of
I
For
4305
Metal cutting
Always use
a
suitable coolant (cutting oil) when cutting metal. Failure to do
so
will cause
significant blade wear. The underside of the workpiece can be greased instead of using
a
coolant.
Plastic base plate
Use the plastic base plate when cutting
decorative veneers, plastics,
etc.
It
protects
sensitive or delicate surfaces from damage.
To
replace the base plate, remove the four
screws with the hex wrench.
Anti-splintering device
To
reduce the potential for workpiece sur-
face splintering, the anti-splintering device
can be used. Fit
it
into the base from
below
so
that
it
surrounds the sides
of
the
blade.
Base Base
Anti-splintering device
ef
12