Filter
Top Products
cutouts
Cutouts can be made with either of
two
methods
A
or
B.
A)
Boring
a
starting hole:
For internal cutouts without
a
lead-in cut from an edge, predrill starting hole more
than
12
mm
(15/32")
in diameter. Insert the blade into this hole and hold the tool
firmly against the workpiece to start your cut.
/
For
4304
Starting
hole
A/
p
Starting
hole
B)
Plung cutting
You need not bore
a
starting hole or make
a
lead-in cut if you carefully
do
as
follows:
1.
Tilt the tool up on the front edge of the base, with the blade point positioned just
2.
Apply firm pressure to the tool
so
that the front edge of the base will not move
3.
As
the blade slices into the workpiece, slowly lower the base of the tool down onto
4.
Complete the cut in the normal manner.
above the workpiece surface.
when you switch on the tool and gently lower the back end of the tool slowly.
the workpiece surface.
For
4304
~
For
4305
11