Filter
Top Products
10
3. Rotate the blade installing lever in the (4) direction
until it stops. The clamp will protrude from the blade
holder.
4. Remove the clamp from the blade holder while
rotating the clamp in the (5) direction.
Installing clamp
1. Make sure that the blade installing lever has been
rotated in the (4) direction until it stops.
2. Insert the clamp into the blade holder while rotating
it in the (6) direction one quarter to one full turn so
that its slot will face forward.
CAUTION:
• Do not rotate the clamp more than one full turn
when inserting in into the blade holder. If you do so,
the blade may not be tightened firmly.
3. Grasp the clamp with your fingers so that it will not
turn, then rotate the blade installing lever in the (7)
direction until it stops. The clamp will go in the
blade holder.
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
1. Blade holder
2. Clamp
1. Blade holder
2. Clamp
1. Blade holder
2. Clamp
1
2
002993
1
2
(5)
002781
(4)
002782
1
2
(6)
002783
1. Blade installing
lever
1. Limit mark
1. Brush holder
cap
2. Screwdriver
(7)
1
002784
1
001145
1
2
002786