Filter
Top Products
Bevel
cutting
CAUTION:
Always remove the battery from the tool before making any adjustments
With the base tilted, you can make bevel
cuts at any angle between
0"
and
45"
(left
or right). Loosen the bolt on the bottom
of
the tool. Move the base
so
that the bolt
is
positioned in the center
of
the cross-shaped
slot in the base.
Tilt the base until the desired bevel angle
is obtained. The edge
of
the motor housing
indicates the bevel angle by graduations.
Then tighten the bolt to secure the base.
Flush cutting
Loosen the bolt
on
the bottom
of
the tool
and slide the base all the way back. Then
tighten the bolt to secure the base.
Cross-shaped
slot
Edge
of
motor housing
rl
I
11