Filter
Top Products
CAUTION:
.The fast charger Model DC1201
is
specifically designed to charge only
Makita
battery
cartridges. Never use
it
for other purposes or for other manufacturer's batteries.
When you charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period of time,
it
may not accept
a
full charge. This
is
a
normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharg-
ing
it
completely and recharging
a
couple of times.
0
If you charge
a
battery cartridge from
a
just-operated tool or
a
battery cartridge which
has been left in
a
location exposed to direct sunlight or heat for
a
long time,
the
charg-
ing light may flash in red color. If this occurs, wait for
a
while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster if you remove the
battery cartridge from the fast charger.
0
If the charging light flashes alternately in green and red color and
a
tone sounds "beep,
beep, beep,
. .
."
for about
20
seconds,
a
problem exists and charging
is
not possible.
The terminals on the charger or battery cartridge are clogged with dust
or
the
battery
cartridge
is
worn out or damaged.
0
If you wish to charge two battery cartridges, allow
15
minutes between chargings on the
fast charger.
Removing
or
installing the
saw
blade
CAUTION
:
Always be sure that the tool
is
switched off and the battery cartridge
is
removed before
installing or removing the blade.
To remove the blade, press the shaft lock
so
that the blade cannot revolve and use
the hex wrench to loosen the bolt counter-
clockwise. Then remove the bolt, outer
flange and blade.
10