Filter
Top Products
Adjusting the depth
of
cut
Loosen the screw on the depth guide and move the base up or down. You can read the
depth of cut by aligning the top of the notch in the depth guide with the graduations on
its
right side. (Note
:
This can be done for
0"
bevel cutting only.) At the desired depth of
cut, secure the base by tightening the screw.
guide
Base
1
Screw
I
Fig.
13
CAUTION
:
Depth guide
Fig.
14
0
Use
a
shallow depth of cut when cutting thin workpiece for cleaner, safer cuts.
0
After adjusting the depth of cut, always tighten the clamp screw securely.
Bevel cutting
Loosen the screw on the bevel
scale
plate
on the front of the base.
Set
for the desired
angle
(0"
-
45")
by tilting accordingly,
then tighten the clamp screw securely.
Screw Bevel scale plate
Fig.
l!
CAUTION
:
After adjusting the depth of cut and bevel cutting angle, be sure to tighten the screw.
12