Filter
Top Products
IMPORTANT
SAFETY INSTRUCTIONS
(For
All Tools)
WARNING:
WHEN
USING
ELECTRIC TOOLS, BASIC SAFE-
REDUCE THE
RISK
OF
FIRE,
ELECTRIC SHOCK, AND PER-
TY
PRECAUTIONS SHOULD ALWAYS
BE
FOLLOWED TO
SONAL INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1.
2.
3.
4.
5.
6.
7.
8.
9.
IO.
11.
12.
KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries.
CONSIDER WORK AREA ENVIRONMENT. Don't use power tools in damp
or
wet locations. Keep work area
well
lit. Don't expose power tools to rain.
Don't use tool in presence of flammable liquids
or
gases.
KEEP CHILDREN AWAY. All visitors should be kept away from work area.
Don't
let
visitors contact tool
or
extension cord.
STORE
IDLE
TOOLS. When not in use, tools should be stored in dry, and high
or
locked-up place
-
out of reach of children.
DON'T FORCE TOOL. It
will
do the job better and safer at the rate for which
it was intended.
USE
RIGHT TOOL. Don't force small tool
or
attachment to do the job
of
a
heavy-duty tool. Don't use tool for purpose not intended.
DRESS PROPERLY. Don't wear
loose
clothing
or
jewelry. They can be caught
in moving parts. Rubber gloves and non-skid footwear are recommended
when working outdoors. Wear protective hair covering to contain long hair.
USE
SAFETY GLASSES. Also use face
or
dust mask if cutting operation
is
dusty.
DON'T ABUSE CORD. Never carry tool by cord
or
yank it to disconnect from
receptacle. Keep cord from heat,
oil,
and sharp edges.
SECURE WORK.
Use
clamps
or
a vise
to
hold
work.
It's safer than using
your hand and
it
frees
both hands
to
operate tool.
DON'T OVERREACH. Keep proper footing and balance at all times.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean
for
better and
safer performance.
Follow
instructions
for
lubricating and changing acces-
sories.
Inspect tool cords periodically and if damaged, have repaired by autho-
rized service facility. Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean, and free from
oil
and grease.
.
DISCONNECT TOOLS. When not in
use,
before servicing, and when chang-
13,
ing accessories, such as blades, bits, cutters.
2