Makita 6071D Cordless Drill User Manual


 
Nominal diameter
(mm)
Bit
No.
Wood
screw
2.1
-
2.7
(3/32"
-
1/8")
Selecting correct Phillips bit
Use the
chart
to determine the best size
driver bit for the size of screw
that
you
wish
to
use.
No.
2
3.1
-
4.5
(118"-
3/16")
Selecting slotted bit
Use
a
slotted bit that properly fits the screw slot. Use of
a
bit
that
is too small will
damage the screw and/or bit.
Installing
or
removing driver bit
CAUTION
:
Always be sure
that
the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
To
install the bit, place
it
in
the chuck as
I
far
as
it
will
go. Tighten the chuck by
hand. Place the chuck key
in
each of the
three holes and tighten clockwise.
Be sure
to
tighten all three chuck holes
even
I
y
.
To remove the bit,
turn
the chuck key
counterclockwise
in
just one hole, then
loosen the chuck by hand.
Chuck
key
Tighten
,-
I
I
Chuck
key
7