Filter
Top Products
0
If
you wish
to
charge two battery cartridges, allow
15
minutes between chargings on the
fast charger.
Installing or removing drill bit or driver bit
CAUTION:
Always be sure that the
tool
is switched
off
and the battery cartridge is removed before
installing
or
removing the bit.
To install the bit, place
it
in the chuck as
far as
it
will go. Tighten the chuck by hand.
Place the chuck key
in
each
of
the three
holes and tighten clockwise. Be sure
to
tighten all three chuck holes evenly.
To
remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
I
Chuck
key
Holding
tool
Hold the
tool
as shown in the figure.
When drilling a large diameter hole, hold
the
tool
firmly with both hands.
7