Filter
Top Products
Charging
Uncao the connector hole.
Connect the charging plug to the charging
connector, then plug in the charger to the
CAUTION
:
The battery in your new tool
is
not fully charged. You will need to charge
it
before use.
Do
not operate the tool during charging.
Overcharging more than
2
days considerably shortens
the
battery service life. Always
unplug the charger after completing the charge. Then cap the charging connector hole.
When you charge
a
new tool or
a
tool which has not been used for
a
long period,
it
may
not accept
a
full charge. This
is
a
normal condition and does not indicate
a
problem.
You can recharge
the
tool fully after discharging
it
almost completely
a
couple of times.
Installing or removing drill bit or driver bit
Always
set
the reversing switch lever to the neutral position before installing or removing
the bit.
To
install the bit, place
it
in the chuck
as
far
as
it
will go. Tighten the chuck by
hand. Place the chuck key in each of the
three holes and tighten clockwise.
Be sure to tighten
all
three chuck holes
evenly.
To
remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
6