Filter
Top Products
Installing or removing the battery cartridge
Always switch off the tool before insertion
or removal of the battery cartridge.
To
remove the battery cartridge, pull out the
set plate on the tool and grasp both sides
of the cartridge while withdrawing
it
from
the tool.
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into place.
Snap the set plate back into place. Be sure
to close the set plate fully before using the
tool.
Fast charger
DC9700
Battery cartridge
9100, 9100A Approx.
60
min.
9101, 9101A
~~
Battery cartridge
DC1201 DC9015 DC9112
Approx.
45
min. Approx. 15 min.
Approx. 60 min.
Approx.
60
min.
- -
Set plate
I’
Do not use force when inserting the battery cartridge. If the cartridge does not slide
in
easily,
it
is not being inserted correctly.
Charging
Plug the fast charger into your power source.
Insert the battery cartridge
so
that the plus
and minus terminals on the battery cartridge
are on the same sides as their respective
markings on the fast charger. Insert the
cartridge fully into the port
so
that
it
rests
on the charger port floor. Press the start
button (red). The charging light will come on
and charging
will
begin.
If
the charging light
does not come on, press the reset button
(yellow) first, then the start button (red). If
the charging light goes out within
10
seconds even after pressing the reset button
Charging light
Start button
Reset button
and start button a couple of times, the battery cartridge is dead. (CAUTION: Wait for more
than
5
seconds after the charging light goes out to press the reset button again.) Replace
it
with a new one. When the charging light goes out
in
a certain time, you may remove
the fully charged battery cartridge. Refer to the table below for the charging time.
7