Filter
Top Products
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period,
it
may not accept a
full
charge. This is a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it
completely a couple of times.
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert
it
and try to charge
it
once more.
Do
not keep the button pressed
in
with tape, etc. or the circuit will not function properly.
Also, a malfunction of the charger may result possibly causing overheating, etc.
If you wish to charge two battery cartridges, allow
15
minutes between chargings on
the fast charger.
Installing
or
removing the bit
CAUTIO
N
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Use only the driver bit or socket bit shown
at right.
Do
not use any other driver bit or
socket bit.
To
install the bit, pull the sleeve in the
direction of the arrow and insert the
bit
into
the sleeve as far as
it
will go. Then release
the sleeve to secure the
bit.
11
mm
4
9
mm
(3/8")
I
7
Bit
I
Sleeve
To
remove the bit, pull the sleeve in the direction
of
the arrow and pull the
bit
out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve, the sleeve
will
not return to its original
position and the bit will not be secured.
In
this case, try re-inserting the bit according to
the instructions above.
8