Filter
Top Products
7
NOTE:
• Even with the switch on and motor running, the bit will
not rotate until you fit the point of the bit in the screw
head and apply forward pressure to engage the clutch.
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the position
for clockwise rotation or the position for counterclockwise
rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing locator assembly
To remove the locator assembly, pull the locking sleeve for-
ward and then turn it counterclockwise. To install the locator
assembly, screw it clockwise and then push the locking
sleeve back in lightly toward the motor. Turn the locking
sleeve slightly to match the locking positions and then push
in firmly to lock the locator in place.
Installing or removing the socket bit
After removing the locator assembly, pull firmly to remove
the magnetic socket bit. To install the bit, insert it into the tool
as far as it will go.
1. Reversing switch lever
1
004159
1. Locking position
2. Locking sleeve
3. Locator
1
2
3
004165
1. Locator
2. Magnetic socket bit
1
2
004167