Filter
Top Products
8
OPERATION
Fit the screw on the point of the bit and place the point of the
screw on the surface of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw the tool as soon as
the clutch cuts in. Then release the switch trigger.
CAUTION:
• When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
• Use the proper bit for the head of the screw that you
wish to use.
• Do not continue unnecessary clutching operation.
NOTE:
Make sure that the bit is inserted straight in the screw head,
or the screw and/or bit may be damaged.
When using insert bit
Fit together the insert bit and magnetic bit holder. Install a
locator assembly for an insert bit.
Then adjust depth setting. Initially, adjust the locator assem-
bly to create a distance of approximately 1 mm from the tip of
the locator to the base of the screw head. Continue adjusting
until the proper depth setting is obtained by following the
method of “Depth adjustment”.
To remove the bit, pull the magnetic bit holder firmly. Hold
the magnetic bit holder in your hand and grasp the bit with a
pair of pliers. Pull the bit out of the magnetic bit holder.
Sometimes, it helps to wiggle the bit with the pliers as you
pull.
1. Locator
2. Insert bit
3. Magnetic bit holder
1
2
3
004184
1 mm
004185