Filter
Top Products
Removing
or
installing bit
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before removing or installing
the bit.
To remove the bit, first pull the front cap
off and then pull the bit firmly. To install
the bit, insert
it
into the tool
as
far
as
it
will go and then replace the front cap.
Depth adjustment
When you wish to drive self drilling screws,
etc.,
adjust the depth
as
follows. Turn the
locator to adjust the depth.
Initially, adjust the locator to create
a
dis-
tance of approximately
1
mm
(3/64”)
from
the tip of the front cap (which works in
conjunction with the locator) to the base
of the screw head. One full turn of the
locator equals
1
mm
(3/64“)
change in
depth. After adjusting the locator, turn
the adjusting ring
so
that the
6”
mark
is
aligned with the pointer on the gear hous-
ing. Drive
a
trial screw into your material
or
a
piece of duplicate material. If the
depth
is
not
suitable
for the screw, con-
tinue adjusting until the proper depth
set-
ting
is
obtained.
I
Adjusting ring-
\\
1
mm
(3/64”)
1
mm
(3/64”)
1
mm
(3/64”)
5