Filter
Top Products
Removing or installing locator assembly
To
remove the locator assembly, pull the
locking sleeve forward and then turn
it
counterclockwise.
To install the locator assembly, screw
it
clockwise and then push the locking
sleeve
back in lightly toward the motor. Turn the
locking sleeve slightly to match the locking
positions and then push in firmly to lock
the locator in place.
Locking position
Locking sleeve-y\
Locator
A
Removing
or
installing bit
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before removing or installing
bit.
After removing the locator assembly, pull
firmly to remove the magnetic bit holder.
Hold the magnetic bit holder in your hand
and grasp the bit with
a
pair of pliers. Pull
the bit out of the magnetic bit holder.
Sometimes,
it
helps to wiggle the bit with
the pliers
as
you
pull.
Locator
Bit
Magnetic bit holder
2
To
install the bit, follow the removal procedures in reverse.
Depth adjustment
Pull the locking
sleeve
forward and then
turn
it
to adjust the depth.
Locator
Locking
Locking
'
/-
position
1
Gear housing
5