Filter
Top Products
Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation. Move the revers-
ing switch lever to the
b
position for
clockwise rotation or the
''g\
position for
counterclockwise.
Reversing
switch
lever
1
CAUTION
:
0
Always check the direction of rotation before drilling.
.Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
Operation
Fit the screw on the point of the bit and
place the point of the screw on the surface
of the workpiece to be fastened. Apply
pressure to the tool,
Start
the tool slowly
and then increase the speed gradually.
Withdraw the tool
as
soon
as
the clutch
cuts in.
CAUTION
:
0
Use the proper bit for the head of the screw that
you
wish to use.
0
When fitting the screw onto the point of the bit, be careful not to push in on the screw.
If the screw
is
pushed in, the clutch will engage and the screw will rotate suddenly. This
could damage
a
workpiece or cause an injury.
0
Do
not continue unnecessary clutching operation.
NOTE
:
Make sure that the bit
is
inserted straight in the screw head, or the screw and/or bit may
be damaged.
MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
To maintain product SAFETY and RELIABILITY, reparis, carbon brush inspection and
replacement, any other maintenance or adjustment should be performed by Makita
Authorized or Factory Service Centers, always using Makita replacement parts.
7