Filter
Top Products
Initially, adjust the locator assembly to create
a
distance of approximately
1
mm
(3/64")
from the tip of the locator to the base of the screw head. One full turn of the locator
equals
1.5
mm
(1/16")
change in depth. After adjusting
the
locator assembly, push the
locking
sleeve
in to lock the locator in place. Drive
a
trial screw into your material or
a
piece
of
duplicate material. If the depth
is
not suitable
for
the screw, continue adjusting
until the proper depth setting
is
obtained.
I
Switch
action
Tool
speed
is
increased by increasing pres-
sure on the trigger.
To
start the tool, simply
pull the trigger.
Release
the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button.
To
stop
the tool from the locked position, pull the
trigger fully, then release
it.
I
1
mm
(3/64")
I
I
I
Trigger switch
Lock
button
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the
"OFF"
position when released.
NOTE
:
Even with the switch on and motor running, the bit will not rotate until you fit the point
of the bit in the screw head and apply forward pressure to engage the clutch.
6