Filter
Top Products
Installing or removing battery cartridge
.Always switch off the tool before insertion or removal of the battery cartridge.
*To remove the battery cartridge, pull out
the
set
plate and grasp both sides of the
cartridge while withdrawing
it
from the
tool.
0
To install the battery cartridge, insert the
battery cartridge into the housing and
snap the
set
plate back into place.
Be
sure
to close the
set
plate fully before using
the tool.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides
as
their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that
it
rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on,
press the reset button (yellow) first, then
button
the start button (red). If the charging light goes out within
10
seconds even after press-
ing the reset button and start button
a
couple of times, the battery cartridge
is
dead.
(CAUTION
:
Wait
for more than
5
seconds after the charging light goes out to press the
reset button again.) Replace
it
with
a
new one. When the charging light goes out after
about one hour, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION:
0
Your new battery cartridge
is
not charged. You will need to charge
it
before use.
.Do
not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also,
a
malfunction of the charger may result possibly causing overheating,
etc.
0
If you try to charge
a
cartridge from
a
just-operated tool, sometimes the charging light
will not come on. If this occurs,
let
the cartridge cool off for
a
while. Then re-insert
it
and try to charge
it
once more.
When
you
charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period,
it
may not accept
a
full charge. This
is
a
normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
almost completely
a
couple of times.
0
If
you
wish
to
charge
two
battery cartridges, allow
15
minutes between chargings on the
fast charger.
6