Filter
Top Products
Installing or removing driver bit
CAUTION
:
Always be sure that the tool
is
switched off and the battery cartridge
is
removed before
installing or removing the bit.
Slide the
sleeve
toward the motor and in-
sert the bit into the
sleeve
as
far
as
it
will
go. Then release the
sleeve
to secure the
bit.
To
remove the bit, slide the sleeve toward
the motor and pull the bit out firmly.
NOTE
:
If the bit
is
not inserted deep enough into the
sleeve,
the
sleeve
will not return to
its
original position and the bit will not be secured.
In
this case, try re-inserting the bit
according to the instructions above.
CAUTION:
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
switch actuates properly and returns to the
"OFF"
position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction
of
rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion or
to
the left for counterclockwise.
CAUTION
:
0
Always check the direction
of
rotation before operation.
*Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
7