Filter
Top Products
CAUTION
:
.The fast charger Model DC1201
is
for charging Makita battery cartridge. Never use
it
for
other purposes or for other manufacturer's batteries.
0
When you charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period of time,
it
may not accept
a
full charge. This
is
a
normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharg-
ing
it
completely and recharging
a
couple of times.
0
If
you charge
a
battery cartridge from
a
just-operated tool or
a
battery cartridge which
has been
left
in
a
location exposed to direct sunlight or heat for
a
long time, the charg-
ing light may flash in red color. If this occurs, wait for
a
while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster if you remove the
battery cartridge from the fast charger.
If the charging light flashes alternately in green and red color and
a
tone sounds "beep,
beep, beep,.
. ."
for about
20
seconds,
a
problem exists and charging
is
not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge
is
worn out or damaged.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing
or
removing bit
CAUTION
:
Always
be
sure that the tool
is
switched off and the battery cartridge
is
removed before
installing or removing the bit.
Use only the driver bit or socket bit shown
in the figure.
Do
not use any other driver bit or socket
bit.
To install the bit, pull the
sleeve
in the
direction of the arrow and insert the bit
into the
sleeve
as
far
as
it
will
go.
Then
release the
sleeve
to secure the bit.
I
Sleeve
I
To remove the bit,pull the
sleeve
in the direction of the arrow and pull the bit out firmly.
7