Filter
Top Products
IMPORTANT
SAFETY
INSTRUCTIONS
(For
All
Tools)
WARNING:
WHEN USING ELECTRIC TOOLS, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE
THE
RISK
OF
FIRE,
ELECTRIC SHOCK, AND PERSONAL
INJURY,
INCLUDING THE FOLLOWING:
READ
ALL INSTRUCTIONS.
1.
KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries.
2. CONSIDER WORK AREA ENVIRONMENT. Don't use power tools
in
damp
or
wet locations. Keep work area well
lit.
Don't expose power tools to rain.
Don't use tool
in
presence of flammable liquids or gases.
3. KEEP CHILDREN AWAY. All visitors should be kept away from work area.
Don't let visitors contact tool or extension cord.
4.
STORE IDLE
TOOLS.
When not
in
use, tools should
be
stored
in
dry, and high
or locked-up place
-
out of reach of children.
5.
DON'T FORCE TOOL.
It
will do the
job
better and safer at the rate for which
it
was intended.
6.
USE RIGHT TOOL. Don't force small tool or attachment to do the
job
of a
heavy-duty tool. Don't use tool for purpose not intended.
7.
DRESS PROPERLY. Don't wear loose clothing or jewelry. They can be caught
in
moving parts. Rubber gloves and non-skid footwear are recommended
when working outdoors. Wear protective hair covering to contain long hair.
8.
USE SAFETY GLASSES.
Also
use face or dust mask if cutting operation is
dusty.
9.
DON'T ABUSE CORD. Never carry tool
by
cord or yank
it
to disconnect from
receptacle. Keep cord from heat, oil, and sharp edges.
10.
SECURE WORK. Use clamps or
a
vise to hold work. It's safer than using
your
hand and it frees both hands
to
operate tool.
11.
DON'T OVERREACH. Keep proper footing and balance at all times.
12.
MAINTAIN
TOOLS
WITH CARE. Keep tools sharp and clean for better and
safer perform.ance. Follow instructions for lubricating and changing acces-
sories. Inspect tool cords periodically and if damaged, have repaired
by
autho-
rized service facility. Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean, and free from oil and grease.
13. DISCONNECT TOOLS. When not
in
use, before servicing, and when chang-
ing accessories, such as blades, bits, cutters.
2