Filter
Top Products
Removing
or
installing
the
outer and inner
sleeves
CAUTION
:
*Always be sure that the tool
is
switched off and unplugged before removing or installing
Be
careful not to allow foreign matter
to
enter the insides of the tool when removing
the outer and inner
sleeves.
or installing the outer and inner
sleeves.
The outer
sleeve
M20
and
inner
sleeve
3/4"
are factory-installed.
If you need other
sizes
for your work, replace the
sleeves
as
follows.
Inner sleeve spring
Loosen the
two
screws while holding the
outer
sleeve.
The outer and inner
sleeves
will
be pushed up by the springs built into
the tool.
I
=-
\\
Press the pin down to remove the inner
sleeve
from the outer
sleeve.
Be
careful not to
drop the inner
sleeve
when removing
it.
Do
not remove the inner
sleeve
spring, tip rod
and tip rod spring from the tool.
1-
Inner sleeve
Hold the inner
sleeve
with the pin facing
upward.
Place
the outer
sleeve
over the
inner
sleeve.
Press the pin to secure
the
inner
sleeve.
Outer
sleeve
in
sleeve
5