Filter
Top Products
9
OPERATION
Hold the tool firmly with both hands. Turn the tool on and wait
until it attains full speed. Gently apply the tool to the work-
piece surface and move the tool forward and back. Press the
belt only lightly on the workpiece. Excessive pressure may
damage the belt and shorten tool life.
Always use "A" range of the belt to sand the workpiece.
CAUTION:
• Secure the workpiece with clamps, etc. if there is any
possibility of it moving during the work operations.
• The tool should not already be in contact with the
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish, damage to the belt of
loss of control of the tool may result.
• When working with the tool, be very careful to avoid any
contact of the tool and belt with any part of your body or
anyone or anything near you.
1. Flat shoe
001223
"A" range
1
001224
001225