Filter
Top Products
To
tighten
the
lock nut, press the shaft lock
firmly
so
that the spindle cannot revolve,
then use the lock nut wrench and securely
tighten clockwise.
1
r
Lock
nut
wrench
Shaft
lock
3-
I
To remove the disc, follow the installation procedure in reverse.
IF
USED
AS A
GRINDER
NOTE:
Use grinder accessories specified in this manual. These must be purchased by separate.
WARN
I
NG
:
Always use guard assembly or accessory kit, noted below, for type 27 depressed center
wheel.
Guard assembly
Part No. 192578-8
...
For 180 mm
(7")
Part No. 192588-5
...
For 230 mm (9")
Installing
wheel
guard
When using a depressed center wheel or an
abrasive cut-off wheel, always use a wheel
guard. Mount the wheel guard with the tab
on the wheel guard band aligned with the
notch on the bearing box. Then rotate the
wheel guard 160 degrees counterclockwise.
Be sure to tighten the screw securely.
Guard accessory kit
Part No. 192606-9
...
For 180 mm (7")
Part No. 192607.7
...
For 230 mm (9")
[-Wheel
guard
7