Filter
Top Products
Installing or removing depressed center wheel
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the wheel.
Mount the inner flange onto the spindle. Fit
the wheel on over the inner flange and screw
the lock nut onto the spindle.
To
tighten the lock nut, press the shaft lock
firmly so that the spindle cannot revolve,
then use the lock nut wrench and securely
tighten clockwise.
To remove the wheel, follow the installation
procedure in reverse
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock lever. To stop the tool from the
locked position, pull the trigger fully, then
release it.
I
Lock
nut
wrench
7
\.&
-I
Shaft
lock
I
l-
-
\-Lock lever
CAUTION:
Before plugging in the
tool,
always check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
8