Filter
Top Products
P 3/10
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Drill chuck (cont.)
DISASSEMBLING
(2) Remove Drill chuck. (Fig. 4)
*Note: The rotational direction is viewed from operator.
1. Grip Hex wrench 10 with Drill chuck and hold Machine.
Important:
Be sure to hold the grip of Machine tightly with sufficient
counterclockwise* force against clockwise* recoil force
of Machine.
2. Pull Switch trigger slowly.
3. Spindle rotates counterclockwise* and consequently
Drill chuck is removed from spindle.
Hex wrench 10
Fig. 4
ASSEMBLING
Fig. 5 Fig. 6
end of the threaded
portion of Spindle
Drill chuck
(1) Set the machine. (Figs. 5, 6)
(2) Set Hex wrench 10 to vise as described in Fig. 3.
Turn Drill chuck clockwise until it sits on
the end of the threaded portion of Spindle.
F/R Change lever
Set Speed change lever
to Low speed mode
indicated by "1".
Set Change ring
to Drill mode.
Speed change lever
Change ring
Set F/R Change lever to
Forward (clockwise) rotation.
Attach battery.
Counterclockwise* force
to be applied by operator
Clockwise* recoil force
of Machine