Filter
Top Products
P 7/10
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Gear assembly and Motor section (cont.)
(5) Engage the notch of Yoke unit with the projection inside of Housing (L) when mounting the assembly of Gear section
and Motor section to Housing (L). (Fig. 12)
(6) Adjust the assembly of Motor section and the Gear section to the correct position in Housing (L)
so as to assemble Housing (R) to Housing (L) smoothly and exactly. (Fig. 13)
Fig. 12
Fig. 13
ASSEMBLING
projection for fitting
to the notch
Engage the notch of Yoke unit with the projection inside of Housing (L).
Housing (L)
notch
Yoke unit
The flat portion of Brush holder must be at
exactly 90 degrees to the edge of Housing (L).
edge of
Housing (L)
Brush holder
complete
Housing (L)
flat portion of
Brush holder
complete
90 degrees
Yoke unit must be mounted
within these ribs.
This rib must be fit in
the groove of Change ring.