Makita DC18RC Battery Charger User Manual


  Open as PDF
of 5
 
[1] DISASSEMBLING / ASSEMBLING
[1]-3 Wiring of Power supply cord and Lead wires of Scirocco fan
Fig. 5
Be careful to route Power supply cord and Lead wires of Scirocco fan into Charger case cover as drawn in Fig. 5.
P 4/ 5
Repair
Make sure that Lead wires of Scirocco fan
is fixed in Lead wire holders.
Make sure that Power supply cord is put
in the labyrinth of Charger case cover.
CN1
Lead wire holders
Lead wires of
Scirocco fan
CN2
CN3 (Connector of
Scirocco fan)
Scirocco fan
[1] -4. Terminal base, Circuit board
Remove Terminal base and Circuit board in accordance with [1]-1 and Fig. 6.
Take the reverse step of Disassembling.
DISASSEMBLING
ASSEMBLING
1. After removing Terminal unit, unscrew a Tapping screw
for fastening Terminal base and Circuit board.
Terminal unit
2. Disconnect the connector of Scirroco fan with CN3 of
Circuit board, then remove Terminal base from Charger
case cover.
3. Circuit board can be removed from Charger case cover.
Circuit board Charger case cover
Terminal base
Fig. 6
Scirroco fan
Tapping
screw
Terminal
base
 previous