Filter
Top Products
P 4/ 5
Repair
[2] DISASSEMBLY/ASSEMBLY FOR DC18WA U
[2] -1. Terminal unit and Charger case complete
Fig. 5
DISASSEMBLING
ASSEMBLING
1. Turn Charger upside down and remove
four Tapping screws.
2. Turn Charger over again and open Charger case complete from
rear side.
Charger case complete
Charger case cover
*Open from
this side
Replace Charger case complete as drawn in Figs. 5 and 6.
Assemble Charger case complete to Charger case cover by
reversing the disassembly procedure.
Be sure to push Power supply cord firmly between the ribs
and the wall of Charger case cover as drawn in Fig. 7.
Note: Terminal unit is fully integral with Charger case complete.
When it is necessary to replace Terminal unit, replacing
Charger case complete and Charging condition label is required.
Fig. 6
Fig. 7
Charging circuit Connector
Power supply cord
3. Hold the connector on Charging circuit and pull up the connector.
Tapping
screws
Indication of
DC18WA U
Terminal unit
Important: After disconnecting the charger from electric outlet, wait more than 5 minutes before repairing work.