Filter
Top Products
10
Blade height adjustment
Blade height adjustment is usually not necessary. However,
if you notice that the blade edge is below the level of the rear
base or protrudes too far from the rear base, proceed as fol-
lows.
Loosen the eight installation bolts and the set plate screws.
Turn the adjusting screws clockwise to retract the blade or
counterclockwise to protrude it. After adjusting the blade
height, tighten the set plate screws and the eight installation
bolts securely.
Socket wrench storage
When not in use, store the socket wrench as shown in the
figure to keep it from being lost.
1. Drum plate
2. Installation bolt
3. Set plate screw
4. Set plate
5. Planer blade
6. Adjusting screw
7. Drum
1
3
2
4
5
6
7
003879
1. Socket wrench
2. Wrench holder
3. Rear base
1
2
3
003882