Filter
Top Products
11
Nozzle assembly and joint (optional accessory)
Nozzle assembly and joint are used when connecting the
tool to vacuum cleaner.
When you wish to perform cleaner operation, connect a vac-
uum cleaner to your tool.
To connect vacuum cleaner, remove the chip guide from the
tool. Place nozzle assembly and joint in its place and then
tighten screws to secure them.
Connect a hose of vacuum cleaner to the joint.
OPERATION
Planing operation
First, rest the tool front base flat upon the workpiece surface
without the blades making any contact. Switch on and wait
until the blades attain full speed. Then move the tool gently
forward. Apply pressure on the front of tool at the start of
planing, and at the back at the end of planing.
The speed and depth of cut determine the kind of finish. The
power planer keeps cutting at a speed that will not result in
jamming by chips. For rough cutting, the depth of cut can be
increased, while for a good finish you should reduce the
depth of cut and advance the tool more slowly.
Front roller
When performing repeated cuts, the use of the front roller
enables quick and effortless return of the tool toward an
operator by raising the back end of the tool so that the tool
blades do not contact a workpiece and then sliding tool on
the front roller.
1. Chip guide
1. Joint
2. Nozzle assembly
3. Hose
1
003884
2
1
3
003885
1. At the start of planing
2. At the end of planing
12
003886
1. Front roller
1
003887