6
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Adjusting depth of cut
The depth of cut can be adjusted within a range of
0 - 3.5 mm (1/8”). Turn the knob on the front of the tool until
the pointer is aligned with the desired cutting depth on the
scale. Set the depth of a cut observing the maximum depth
which is limited by width according to the following table.
Switch action
CAUTION:
• Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the “OFF”
position when released.
• Switch can be locked in “ON” position for ease of
operator comfort during extended use. Apply caution
when locking tool in “ON” position and maintain firm
grasp on tool.
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch trig-
ger fully, then release it.
1. Knob
2. Scale plate
1
2
003869
Width of cut
0 - 150 mm (0 - 5-7/8”)
150 - 240 mm (5-7/8” - 9-1/2”)
240 - 312 mm (9-1/2” - 12-1/4”)
Maximum depth of cut
3.5 mm (1/8”)
2 mm (3/32”)
1.5 mm (1/16”)
Corelation of width of cut and maximun depth of cut
003870
1. Switch trigger
2. Lock button
1
2
003871