Filter
Top Products
29
Make sure that the two pointers on the arm point to
each 0° on the bevel scale on the arm holder. If they
do not point to 0°, loosen the screws which secure
the pointers and adjust them so that they will point
to 0°.
(2) 45° bevel angle
Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment. To adjust left 45° bevel
angle, loosen the lever and tilt the blade to the left
fully. Make sure that the pointer on the arm points to
45° on the bevel scale on the arm holder. If the
pointer does not point to 45°, turn the left 45° bevel
angle adjusting bolt on the side of the arm holder
until the pointer points to 45°.
To adjust right 45° bevel angle, perform the same
procedure described above.
Replacing fluorescent tube
CAUTION:
• Always be sure that the tool is switched off and
unplugged before replacing the fluorescent tube.
• Do not apply force, impact or scratch to a fluorescent
tube, which can cause a glass of the fluorescent tube to
be broken resulting in a injury to you or your bystanders.
1. Bevel scale
2. Screws
3. Pointers
2
1
3
3
001572
1. Arm holder
2. Right 45° bevel angle adjusting
bolt
3. Left 45° bevel angle adjusting bolt
1
3
2
001573
1. Pull out 2. Push
3. Lamp box 4. Screws
5. Fluorescent tube
1
2
3
4
1
5
002028