Makita LS1214F Saw User Manual


 
19
Example:
When cutting workpieces 120 mm (4 - 3/4)
high, use a wood facing with the following
thickness.
CAUTION:
Use screws to attach the wood facing to the guide
fence. The screws should be installed so that the
screw heads are below the surface of the wood
facing.
When the wood facing is attached, do not turn the
turn base with the handle lowered. The blade and/
or the wood facing will be damaged.
9. Groove cutting
A dado type cut can be made by proceeding as fol-
lows:
Adjust the lower limit position of the blade using the
adjusting screw and the stopper arm to limit the cut-
ting depth of the blade. Refer to Stopper arm sec-
tion described previously.
After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the work-
piece using a slide (push) cut as shown in the fig-
ure. Then remove the workpiece material between
the grooves with a chisel. Do not attempt to perform
this type of cut using wide (thick) blades or with a
dado blade. Possible loss of control and injury may
result.
CAUTION:
Be sure to return the stopper arm to the original
position when performing other than groove cutting.
Carrying tool
Make sure that the tool is unplugged. Secure the blade at
0° bevel angle and the turn base at right miter angle fully.
Secure the slide poles after pulling the carriage toward
you fully. Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
Carry the tool by holding both sides of the tool base as
shown in the figure. If you remove the holders, dust bag,
etc., you can carry the tool more easily.
CAUTION:
Always secure all moving portions before carrying
the tool.
Stopper pin is for carrying and storage purposes
only and not for any cutting operations.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
WARNING:
Always be sure that the blade is sharp and clean for
the best and safest performance.
Adjusting the cutting angle
This tool is carefully adjusted and aligned at the factory,
but rough handling may have affected the alignment. If
your tool is not aligned properly, perform the following:
1. Cut grooves
with blade
Miter angle Thickness of wood facing
0˚ Over 20 mm (13/16")
Left and Right 45˚ Over 15 mm (9/16")
Right 52˚ Over 15 mm (9/16")
006475
1
001563
1. Stopper pin
1
001564
002025