Filter
Top Products
16
ENGLISH
ENG
8.2 Tightening/loosening the clamping nut
Securing the clamping nut (12):
See illustration d on page 3.
The 2 sides of the clamping nut (12) are different.
Screw the clamping nut onto the spindle (15) as
follows:
-
A) In the case of thick (6 mm) accessories:
The collar of the clamping nut (12) faces down-
wards so that the clamping nut can be attached
securely to the spindle.
B) In the case of thin (3 mm) accessories:
The collar of the clamping nut (12) faces upwards
so that the thin accessory can be clamped
securely.
- Lock the spindle (15) using the Allen key (17).
Tighten the clamping nut (12) by turning it clock-
wise using the 2-hole spanner (18) (see illustra-
tion c, page 3).
Releasing the clamping nut:
- Lock the spindle using the Allen key (17).
Remove the clamping nut (12) by turning it
anticlockwise using the 2-hole spanner (18)
(see illustration b, page 3).
9.1 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the
accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits. After switching off the
machine, only place it down when the motor has
come to a standstill.
Avoid switching on the machine accidentally:
always switch it off when the battery pack is
removed from the machine.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand in a
safe position and concentrate.
Switching on:
Push the slide switch (5) forward.
For continuous operation, flip the switch down
until it locks in place.
Switching off:
Press the rear end of the slide
switch (5) and release.
9.2 Working instructions
Press down lightly on the machine and move over
and back across the surface.
Motor cleaning:
blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine must
be held firmly.
The electronic signal display (6) lights up
and the load speed decreases.
The
temperature is too high! Run the machine in
idling until the electronics signal indicator switches
off.
The electronic signal display (6) flashes
and the machine does not start.
The
restart protection is active.
The machine will not start if the battery pack is
inserted while the machine is on. Switch the
machine off and on again.
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
9Use
9A
9B
10 Cleaning
11 Troubleshooting
12 Accessories
0
I
8
17027055_0411 KNS 18 LTX 150.book Seite 16 Dienstag, 26. April 2011 2:46 14