Milan Technology T1E1-CF-01(LH) Welding System User Manual


 
INSTALLATION
Set Switches
Use small flatblade screwdriver or
similar device to set recessed
switches for site installation. Refer
to label on top of media converter
for MDI/ MDI-X switch settings.
Refer to drawings below and at right
for four-position switch settings.
5. Is the AISTP LED on either media converter illuminated?
YES
Determine and correct failure of remote unit connected to twisted-
pair interface that caused All Ones Insertion (AIS) on the twisted-
pair interface.
NO
Contact Technical Support: (800) 260-1312/(800) LAN-WANS.
SHORT HAUL Switch Settings
Switch #4 UP
12
12
12
12
12
12
12
12
12
E1 2.37V
75 ohm cable
Coax connectors
E1 3.0V
120 ohm cable
RJ-45 connector
DSX-1 0'-133'
100 ohm cable
DSX-1 133'-266'
100 ohm cable
DSX-1 266'-399'
100 ohm cable
DSX-1 399'-533'
100 ohm cable
DSX-1 533'-655'
100 ohm cable
ANSI T1.403
100 ohm cable
DSX-1 6.0V
100 ohm cable
1 2 3 4
*LONG HAUL Switch Settings
Switch #4 DOWN
1 2 3 4
12
12
12
12
0 db
-22.5 db
-15 db
-7.5 db
*Switch #3 not used
for long haul settings.
1 2 3 4
5 6 7 8
KEY
= UP
= DOWN
Fiber
TP
TP
AISTP