Filter
Top Products
OM-230 300 Page 18
4-15. Installing Welding Gun
804 730-A
1 Gun Locking Tab
2 Power Clamp Knob
3 Power Pin Groove
4 Gun Connection End
Installing gun with Accu-Mate connec-
tion
Loosen power clamp knob to allow power
pin of gun to clear the gun locking tab.
When installing gun, the liner should extend
into the PD continuous guide (or exit guide
if used) as far as possible without interfer-
ing with the guide.
Align the groove in the power pin of the gun
with the gun locking tab.
Secure gun by tightening power clamp
knob.
Installing gun without Accu-Mate con-
nection
When using a gun without the groove in the
power pin, loosen power clamp knob and
rotate gun locking tab 180 degrees. This
prevents the locking tab from extending into
the power pin gun connection.
When installing gun, the liner should extend
into the PD continuous guide (or exit guide
if used) as far as possible without interfer-
ing with the guide.
Secure gun by tightening power clamp
knob.
2
Installing gun with
Accu-Mate connection
Installing gun without
Accu-Mate connection
3
1
2
1
4